Table of Contents
Advertisement
7. Installation
The washer is recommended to be installed by a professional service engineer.
Before installation
After installation
1. Determine the location for installation
- Determine the installation site after discussing
the site structure with the customer.
* Breast-high location is convenient for installation.
* Installation and use are convenient with access to
water supply, drainage, and electric outlets.
4-1. Drill a hole through tile
- Notch below the marking hole.
- Drill a hole perpendicular to the wall surface.
* Do not drill a hole on the edge of wall tile.
* Do not drill a hole right below the faucet.
6. Fix set anchors
- Fix set anchors with an anchor hammer.
* Redo the fixation if the anchor cap protrudes
above the wall surface after fixation.
DWM30-999PG(영_SM).indd 45
Install the washer without plugging in the power cord.
Perform a test run to identify any water leaks or abnormal noise.
2. Inspect wall
- Knock on the wall with your hand to check the
existence of retaining wall inside.
* Install the washer on an even wall.
4-2. Drill a hole into the retaining wall
- Set the hammer drill perpendicular to the wall
surface and then drill a hole into the retaining
wall.
* Follow the instructions on the diameter and depth
specifications for the hole.
* Remove dirt from inside the hole.
7. Connect inlet and drain hoses
- Insert the inlet hose until the elbow makes a
snapping sound.
- Connect the clamp inside the synchronous motor after
fixing the drain house to the synchronous motor.
<Check filter_Option>
* Connect hoses properly to prevent leaks.
* Insert the inlet/drain hoses into the back holes
after connection.
3. Attach installation instruction manual
- Use a level meter for attachment.
- Attach a guide and mark the hole spot.
* Attach the manual in consideration of actual
product size.
5. Insert set anchors (4 holes)
- Insert set anchors into holes.
- Set anchors are included in the product
package.
* Insert set anchors to the end of holes.
* The set anchor bolt must be 75mm long or longer
above the wall.
8. Connect the power cord
- Connect the power cord as requested by the
customer (upward, downward).
- Attach a connector and fix the grounding wire.
* Fix the upward power cord tight with clamp cords.
* Fix the grounding wire with grounding screws.
* Do not ground multiple grounding wires in a single
place.
45
16. 8. 23. 오전 10:10
Advertisement
Table of Contents
