Table of Contents
Advertisement
2-2. Rinse Cycle
1) Drainage
1 If the water is 45°C or hotter, cold water is added to lower the water temperature. When the water
temperature decreases to 45°C or lower, water drainage resumes.
2 After the water drainage starts, the drain pump continues to work.
3 If the water level lowers to the reset level within 60 seconds, the waiting time of 20 seconds applies.
Otherwise, the waiting time of 40 seconds applies.
2) Intermediate Spin
1 Intermediate spin is run at the pre-determined speed for each program.
Category
Program
Normal
Delicate
Tub clean
Baby Care
SPIN
QUICK15
INTENSIVE(40,60)
3) Water Supply
1 Only cold water is supplied to the rinse cycle.
2 Fabric softener is added to the final rinse cycle.
4) Resupply of Water
1 The water level is measured a minute after the rinse cycle starts to determine whether water needs to be
added to raise the water level to the preset level.
2-3.Spin Cycle
1) Drainage
1 It is equivalent to the drainage cycle for rinsing.
2-3.Spin Cycle
1) Termination of Door Lock
1 After the electric signal to door lock is cut off, the door is shaken horizontally until it becomes mechanically
openable.
DWM30-999PG(영_SM).indd 18
RPM
700
400
700
700
-
700
700
18
16. 8. 23. 오전 10:10
Advertisement
Table of Contents
