Table of Contents
Advertisement
Defects and
Errors
Non-
Power cutoff or
openable
forced shutdown
Door
during operation
The washer is "ON"
without any power
cutoffs.
Others
* Exchange of Door Lock Switch
[Disassembly]
1. Remove 4 body-fixing screws
2. Remove the detergent and softener containers
3. Remove 2 screws fixing the door hinge
4. Remove 6 cover screws fixing the cover tub
5. Remove 6 screws fixing the cover tub
6. Remove 2 screws fixing the door lock switch
7. Detach the door lock switch and F-PCB
connector
[Assembly]
Re-assemble the parts in the opposite sequence to
disassembly .
DWM30-999PG(영_SM).indd 43
Details
Causes
After the "power cutoff" or "forced shutdown" during operation,
"PCB MICOM" is not able to open the door. At least 5 minutes
must pass before the door becomes openable.
Water in tub
High
temperature in
tub
Inspection of Defects and
Errors
Check whether the water level is above the
safety level.
The door is automatically locked to prevent
damage from hot laundry after the spin
cycle is complete.
The door is automatically locked when the
connector, terminal, or solenoid wire gets
disconnected during operation. The
following instructions must apply to inspect
defects.
* Check the wire connections in Door Lock Switch
PIN
Arranage
ment
2 3 4 5
(No.1 wire unavailable)
43
Error
Resolution
Mode
16. 8. 23. 오전 10:10
Advertisement
Table of Contents
