Battery And Charging - Siemens S42 User Manual

Siemens cell phone user guide
Table of Contents

Advertisement

6

Battery and charging

Slide the battery lid back into
Insert battery
position.
Remove the battery lid by
pressing and sliding it towards
yourself.
1
Insert the battery. Please
make sure that the contact
pins are facing against each
other.
2
Getting started
3
Facts & Tips
• When removing the battery your
phone should always be switched off.
• The on/off key is the left-hand func-
tion key on your phone.
Getting started
Charge battery
Insert the charger plug at the
bottom of the telephone, and
it will start charging immedi-
ately.
Fully charging the battery
takes up to 120 minutes,
depending on the type of
charger used.
Facts & Tips
• When your battery needs recharg-
ing, the phone will emit a short warn-
ing tone and inform you in the display
that the battery needs charging, and
the LED on top of the telephone will
emit a fast red flash.
• If you don't connect the charger
within a short while, the telephone
will switch off automatically.
• If the battery is completely dis-
charged, it may take up to 15 minutes
before any information is shown in
the display.
Remove charger
• The phone will inform you when the
Press 1 and pull out the charger
charger has been connected
plug.
correctly.
7
• During charging the top icon of the
battery indicator will animate a
charging sequence changinging from
to
. When the battery is fully
charged, the top icon will turn perma-
nently into
and the indicators
beneath it will be filled.
• In the Setup menu under Graphics
you can choose other kinds of battery
indicator symbols.
• To maintain an accurate battery
capacity indication, it is recommend-
ed to let the battery discharge com-
pletely from time to time .
• It is possible to use your phone
during charging.

Advertisement

Table of Contents
loading

Table of Contents