Operation; Program And Manual Modes; Console And Functions - Proflex VB400 User Manual

VB400 Vibration Platform

Operation

Program and Manual Modes

The vibration platform features two basic operating modes:
Manual Mode – The machine is being used, but not running a preset program (see Program mode,
•
below). In this mode, the machine will continue for the duration of the countdown timer at the current
speed until you stop the machine, change the speed, timer etc. To enter Manual mode, turn the machine
on, then press ON / OFF.
• Program Mode – The machine runs through a preset routine where it will automatically apply several
speeds over the session duration. There are 5 preset routines to choose from ("P1" to "P5"). To enter
Program mode, turn the machine on, then press PROG MODE [P on remote control]. Press repeatedly
to step through programs. At the desired program, press ON / OFF.

Console and Functions

The machine features a computerized display that provides you with
controls for operating the unit as well as workout information, such as
duration, speed etc.
To use the machine:
1. Plug the machine into a compatible electrical supply (1).
2. Place the power switch, located at the lower front of the unit, in the
"ON" ("I") position (2).
3. Operate the machine as desired.
The machine is equipped with a remote control unit that replicates the
console functions. When using the machine, it may be easier to use
remote control to operate it.
Console/Remote
Control Function
Display
ON / OFF
PRG MODE / P
(remote control)
E&OE
Description
Shows various sessions information, such as remaining time, program mode (if
selected) and animation.
Press to switch the machine ON and OFF. Note that the main power switch
[next to the electrical lead] must be in the ON position.
When the machine is on but not running, press to enter Program mode. Press
repeatedly to step through programs. The current program number is shown in
the display.
©2017 Proflex
2
1
4