Table of Contents
Advertisement
Verifying Correct Operation of the Outdoor Unit
5.
VERIFYING CORRECT OPERATION OF THE
OUTDOOR UNIT
To verify correct operation, view the LED indicators located on the bottom panel
of the Outdoor unit as shown in Figure 2-6 on page 12.
The following table lists the various LED states.
Name
ALARM
WLNK
ETH
RSSI
Note:
SU-A/E Subscriber Units Installation Manual
Table 5-1: SU-RA/RE Outdoor Unit LEDs
Description
Alarm
Indication
Wireless link
activity
Ethernet
activity
Bar display
Yellow LED
8 Green LEDs
Red LED
Verifying proper operation of the Outdoor unit using the LEDs as described
above is possible only after completion of the configuration and alignment
processes.
Functionality
On – A problem with the power amplifier or in
the locking process of any of the synthesizers
Off –Normal operation
Blinking –Receiving packet from the wireless
link
Off – No reception of packets from the wireless
link
Blinking – Data received from or transmitted to
Ethernet LAN
Off – No activity on the Ethernet LAN
Displays the Received Signal Strength Indication.
The higher the number of green LEDs that are
ON, the higher the level of the received signal.
On - Power On
Off – Power is not received from the Indoor
unit
RSSI in 4 dB resolution starting at –91dBm
Received signal strength is –40dBm or higher
20
BreezeACCESS 2.4 Series
Hide quick links:
Advertisement
Table of Contents
