Basic Installation
2.5.2 Connecting the Antenna Cable (SU-RE)
Connect an RF cable between the ANT connector (located on the top panel of
the SU-RE unit) and the antenna.
2.5.3 Connecting the Ground and IF Cables
The Ground terminal (marked
located on the bottom panel of the SU-RA/RE Outdoor unit, shown in
Figure 2-6.
1. Connect one end of the ground cable to the Ground terminal and connect the
other end to a good ground connection.
2. Connect the coaxial cable to the IF connector. Verify that the length of the
IF cable is sufficient and that it can easily reach the Indoor unit.
Note:
SU-A/E Subscriber Units Installation Manual
E T H
W L N K
A L A R M
Figure 2-6. SU-RA/RE Outdoor Unit Bottom Panel
Make sure to switch OFF the power of the SU-NI unit prior to
connecting/disconnecting the IF cable.
and the IF cable connector (marked IF) are
R S S I
12
Ground
IF
Screw
BreezeACCESS 2.4 Series