Installing The Su-Ni Indoor Unit; Figure 2-7. Su-Ni Rear Panel (Unit With Voice Support) - BreezeCOM SU-A-2.4 Series Installation Manual

2.6 Installing the SU-NI Indoor Unit

1. Place the SU-NI unit in an appropriate location on a shelf or a table. The unit
can be wall mounted using the installation materials provided with the unit.
Use a 6mm (1/4") drill and the supplied template plate for easy and accurate
marking of the holes.
2. Connect the SU-PS DC power cord to the DC In jack (marked DC-12V)
located on the rear panel of the Indoor unit (shown in Figure 2-7).
3. Connect the IF cable to the IF connector (marked IF) on the rear panel of the
Indoor unit. The other side of the IF cable should already be connected to the
Outdoor unit.
4. Connect the mains power cord to the SU-PS. Connect the mains power plug
to a mains power outlet.
Note:
5. Verify that the Power LED (marked PWR) located on the front panel of the
Indoor Unit is turned ON.
BreezeACCESS 2.4 Series
E T H
D C -12V

Figure 2-7. SU-NI Rear Panel (unit with voice support)

The rear panel pictured above in Figure 2-7 is of a SU-NI with voice
support; SU-NI units that belong to Subscriber Units without voice support
(SU-1D, SU-8D, SU-BD) are identical, except that they have no TEL port.
T E L
13 SU-A/E Subscriber Units Installation Manual
Basic Installation
IF