Seizmik 18071 Owner's Installation & Operations Manual

Installation & Operations Manual for Pursuit Side View Mirror
Contents:
Left Mirror and Clamp Assembly
For 1.75" Clamp Only!
2.
Place the self adhesive thin
rubber shim in this location.
Rubber Shim
Open clamp and place around roll
cage tube. Make sure the rubber
shim is in place in the thick half of
the clamp.

Initial Adjustment:

Slide mirror up or down Roll Cage
tube to desired location.
Rotate mirror on clamp so that it is
level. When you are satisfied with
the location and angle, tighten
bolt.
Right Mirror and Clamp Assembly
3.
Close clamp around roll cage
tube, put the bolt through the
hole, and place large rubber
washer over the end of the bolt.
Pursuit Mirror # 18071 & 18072

Installation:

1.
Temporarily remove this socket head bolt using a 8mm
Allen Wrench
4.
The Mirror Housing has 3 detent positions.
Position 1 is for the drivers side, position 2
is passenger side, and position 3 is
completely folded. Once the detent position
is selected you can fine tune the viewing
angle by moving the mirror glass within the
housing.
2
1
Using the 8mm wrench,
screw the bolt into the
mirror but do not tighten
yet.
3
1