Advertisement
Quick Links
RANGER XP 1000 2 Seat Seizmik
Skid Plate Manual
Part # 76-10163
Always observe the warnings and precautions in this manual when using your Seizmik products. For best results, carefully
follow the instructions in this manual and make no modifications.
If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM
and 5:00PM EST. You can email us at
support@seizmik.com
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Seizmik 76-10163
Summary of Contents for Seizmik 76-10163
- Page 1 Skid Plate Manual Part # 76-10163 Always observe the warnings and precautions in this manual when using your Seizmik products. For best results, carefully follow the instructions in this manual and make no modifications. If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM and 5:00PM EST.
- Page 2 View looking up at the underside of the vehicle Front Rear...
-
Page 3: Parts List
Parts List 76-10192 76-10193 76-10194 76-10195 76-10196 76-10197 76-10198 99-10006 Skid Plate Washer Tapered Hex Screw M6x25mm M6 Clip Nut Skid Plate Insert Washer... - Page 4 ALL GREEN holes use M6x25mm tapered bolt and washer into factory threaded holes. YELLOW holes use M6x25mm tapered bolt and washer into clip nuts unless called out otherwise. ALL ORANGE holes use M6x35mm flange head bolt and insert washer placed into factory hole in sheet metal.
- Page 5 Uses OEM Threaded holes Bolts thread into clip nuts Uses insert washer into sheet metal hole...
- Page 6 Attach all clip nuts to specified holes in metal brackets. Threading should face upwards, toward vehicle...
- Page 7 Threading should face upwards, toward vehicle To start, remove stock skid plate. Then, attach clip nuts to vehicle undercarriage in locations shown (Shown in YELLOW). Clip nut threads should face upward, toward vehicle. Place insert washers in Sheetmetal holes in vehicle (Shown in ORANGE). Side shown faces upwards, toward vehicle...
- Page 8 Begin with these green holes To start, loosely install the center 3 bolts and washers (Shown in GREEN) so that the middle panel is held in place on its own. Next, attach the metal brackets to the middle panel using 2 bolts and washers (shown in GREEN) and 2 bolts and washers (Shown in YELLOW) into the clip nuts that you attached to the metal brackets.
- Page 9 M6x25mm Tapered Bolt...
- Page 10 Clip Nut attaches directly to vehicle Clip Nut attaches to metal bracket NOTE: Spacer goes between vehicle and rear panel M6x35mm Bolt with a clip nut attaching to vehicle...
- Page 11 NOTE: Spacer goes between vehicle and rear panel M6x35mm Bolt...
Need help?
Do you have a question about the 76-10163 and is the answer not in the manual?
Questions and answers