Advertisement
Table of Contents
Installation & Operations Manual
Kubota RTV X 900 1120D - 2 Piece Hood Rack
Installation information:
• This product has an installation rating of: Easy
• Approximate installation time: 30 Minutes
• This product is easiest to install with: 2 people
Seizmik makes Windshields, Doors, Tops, Hood Racks, Brush Guards, and other great accessories for utility
vehicles & side x sides. Our products are engineered tough for long life and tested under the harshest of conditions.
Always observe the warnings and precautions in this manual when using your Seizmik products. For best results,
carefully follow the instructions in this manual and make no modifications.
Seizmik products are designed, developed and manufactured by Vialink Corp. If you have any questions,
comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM and 5:00PM EST.
You can email us at
support@seizmik.com
Part Number
#08072
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Seizmik 08072
Summary of Contents for Seizmik 08072
- Page 1 & side x sides. Our products are engineered tough for long life and tested under the harshest of conditions. Always observe the warnings and precautions in this manual when using your Seizmik products. For best results, carefully follow the instructions in this manual and make no modifications.
-
Page 2: Parts List
Parts List Parts: 2 Piece Basket Front riser/Light Mounting Plate Bumper Mount Hardware: Front clamp (2) (16) M6 16mm Socket Head Bolts Rear clamp (2) (1) M6 30mm Socket Head Bolt (1) M6 35mm Socket Head Bolt Hood Rack Bracket (L,R) (16) M6 Flat washers Extendable Tubes (2) (18) M6 Lock Nuts... -
Page 3: Important Notes
Important Notes Bumper Mount and Front Clamp Assembly Clamp Orientation and adjustment M6x16mm Spin lever to adjust clamping force Front of Vehicle To open a clamp, lift up on both levers in the order 3. Attach the two front clamps (D) to the bumper mount (C) above. -
Page 4: Riser Assembly
Riser Assembly Locking Bolt 7. Note the riser orientation shown above. Insert the 2 Front riser stems into the front riser/light mounting plate a few inches in. Tighten the locking bolt at the top of the tube with hex key just enough to hold the riser stems in place. - Page 5 How to get Help - If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM and 5:00PM EST. You can email us at support@seizmik.com, visit www.seizmik.com to download installation guides and product info, or contact your powersports dealer where you purchased your Seizmik product if you need additional assistance.
Need help?
Do you have a question about the 08072 and is the answer not in the manual?
Questions and answers