Advertisement
Quick Links
RZR XP 1000 2 Seat Seizmik
Skid Plate Manual
Part # 76-10165
Always observe the warnings and precautions in this manual when using your Seizmik products. For best results, carefully
follow the instructions in this manual and make no modifications.
If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM
and 5:00PM EST. You can email us at
support@seizmik.com
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Seizmik 76-10165
Summary of Contents for Seizmik 76-10165
- Page 1 Skid Plate Manual Part # 76-10165 Always observe the warnings and precautions in this manual when using your Seizmik products. For best results, carefully follow the instructions in this manual and make no modifications. If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM and 5:00PM EST.
- Page 2 View looking up at the underside of the vehicle Front Rear...
-
Page 3: Parts List
Parts List 1.75” Wrap Around Clamp M6 Clip Nut Skid Plate Washer Tapered Hex Screw M6x25mm Skid Plate Insert Washer... - Page 4 GREEN holes use M6x25mm tapered bolt and washer into factory threaded holes BLUE holes use M6x35mm with wrap around clamp YELLOW holes use M6x16mm bolt and washer into clip nuts attached to metal brackets. ORANGE holes use M6x25mm tapered bolt and insert washer placed into factory hole in sheet metal RED holes use Self Tapping Screws- Some locations may or may not require pre-drilling of 1/8”...
- Page 5 Uses OEM Threaded holes Uses Clamps 16mm bolt threads into brackets with clip nuts Uses insert washer into sheet metal hole Self Tapping Screws-May or may not require predrilling of 1/8” pilot hole.
- Page 6 Uses OEM Threaded holes Uses Clamps 16mm bolt threads into brackets with clip nuts Uses insert washer into sheet metal hole Self Tapping Screws-May or may not require predrilling of 1/8” pilot hole.
- Page 7 Attach all clip nuts on to slotted holes in metal brackets. Threading should face upwards, toward vehicle...
- Page 8 Insert Washer To start, remove stock skid plate. Then, place insert washers (Shown in ORANGE) into holes in Sheetmetal. Side shown faces upwards, toward vehicle. Snap clamps (Shown in BLUE) around metal tubing in general location shown. Threading should face inward. 1.75”...
- Page 9 25mm Self Tapping Screw M6x16mm Bolt threads into Clip Nut To start, loosely install the center 3 bolts and washers (Shown in RED) into pre-existing holes so that the front panel is held in place on its own. Next, loosely attach the metal brackets to the front panel using 4 bolts and washers (Shown in YELLOW) into the clip nuts that you attached to the metal brackets.
- Page 10 M6x16mm Bolt...
- Page 11 M6x25mm Tapered Bolt...
- Page 12 M6x25mm Tapered Bolt and Insert Washer 1.75” Wrap Around Clamp M6x35mm Bolt NOTE: Spacer goes 50mm Self Tapping Screw between vehicle and rear panel...
- Page 13 25mm Self Tapping Screw 38mm Self Tapping Screw...
Need help?
Do you have a question about the 76-10165 and is the answer not in the manual?
Questions and answers