H3C S5130S-EI series Installation Manual page 18

Figure 13 Installing the switch on a wall (1)
Drill two holes with a diameter of 6 mm (0.24 in) and a depth of 25 mm (0.98 in) at the marked
2.
locations. Hammer the screw anchors into the wall and use a Phillips screwdriver to fasten the
screw into the screw anchor. Leave 1.5 mm (0.06 in) between the screw head and the wall for
hanging the switch.
Figure 14 Installing the switch on a wall (2)
Align the installation holes in the switch rear with the screws on the wall and hang the switch on
3.
the screws. Make sure the port side faces down and the left and right sides are perpendicular to
the ground.
Figure 15 Installing the switch on a wall (3)
11