Care And Cleaning; Cleaning The Blender And Accessories - KitchenAid KSB60 series Manual

CARE AND CLEANING

CLEANING THE BLENDER AND ACCESSORIES

Clean the Blender thoroughly after every use.
NOTE: To avoid damaging the Blender, do not immerse the blender base
or cord in water. To avoid scratching the Blender, do not use abrasive cleansers
or scouring pads.
To clean the blender base and cord:
Unplug the Blender before cleaning.
1
Wipe the base and the cord with a
warm, damp cloth; wipe clean with a
damp cloth, and dry with a soft cloth.
Rotate the control dial to Max. Flip
the START/STOP toggle switch up or
down. Run the Blender on the Max
speed setting for 35 seconds. Flip
the START/STOP toggle switch up or
down to stop the Blender. When the
3
blade stops spinning, pour out the
soapy water, and rinse the blender
jar with warm water. When cleaning
after some recipes (hummus, nut
butters) it might be necessary to
repeat these steps.
Make sure to clean the blender jar,
lid, and ingredient-measuring
cap after each use. Remove any
remaining contents from the blender
jar using a spatula and rinse with
2
hot water. Fill jar with 24 oz. of hot
water and add 3-4 drops of liquid
dishwashing detergent. Place the lid
on the blender jar, and make sure
the blender jar is fully in place on the
blender base.
The blender jar, lid, tamper, and
ingredient-measuring cap are
dishwasher safe; the tamper, lid, and
ingredient-measuring cap should
be placed in the top rack of the
4
dishwasher. If preferred, all parts may
also be washed by hand with a damp
cloth and warm soapy water, and then
rinsed with warm water and dried
with a soft cloth.
CARE AND CLEANING | 9