KitchenAid KHBRV00, KHBRV71 - Cordless Hand Blender Manual

GETTING STARTED

BEFORE FIRST USE

1. Charge the Battery until it is fully charged.
2. Clean all the parts and accessories (see "Care and Cleaning" section).
3. Remove all packaging materials, if present.
   NOTE: Some dust may be on the product. This is due to the recycled materials used in packaging. This can be cleaned with a soft towel.

BATTERY CHARGING

USING THE USB CABLE

1. Attach the USB Cable to the adapter. Connect the other end of the USB Cable to the Battery.
2. Plug the adapter into a power source.

USING THE DOCKING STATION (OPTIONAL)

1. Attach the USB Cable to the adapter.
2. Plug the adapter into a power source.
3. Turn the Battery upside down and slide the Battery onto the dock. Then press down and the latch will snap into place.
4. Upon initial plugging in the Battery into the charger, the Battery LEDs will alternate for a few seconds as it performs a self-diagnostic of the Battery status.
5. After diagnostic is complete, the Battery will begin charging with a single LED flashing. LEDs will become solid in color as charging progresses. Battery is fully charged when all LEDs are solid.
   NOTE: If initial alternating light pattern continue for more than 10 seconds, the Battery may be too warm or too cold to charge. Unplug Battery and allow it to stabilize to a normal room temperature and try charging again. If Battery still not charge after this, unplug Battery and contact customer service.

BATTERY STATUS

LED INDICATION	BATTERY LEVEL
	75-100%
	50-75%
	25-50%
	< 25%
	When Battery has only 10% Battery level, 1 LED start to flash at rate of 1 second ON / 1 second OFF (0.5 Hz).

LED Legend Indication:
= ON
= OFF
= FLASH
NOTE: When the Battery is installed or when the appliance is operated, the Battery charge status LEDs will display for 5 seconds and then turn off. If the Battery charge is 10% or less, the indication light will continue to flash until the unit is no longer in use or Battery is removed.
Full Charge: The Battery will be fully charged in around 3 hours.
NOTE: It is best to store the Cordless Hand Blender at room temperature.

PRODUCT USAGE

NOTE: Do not place the adapter in an area of extreme heat or cold. It will work best at normal room temperature.

Make sure that the Variable Speed Controller is not pressed and the Battery is removed before attaching or removing parts or accessories.

1. Insert the Battery on the Battery slot located at the top of the appliance, make sure it is aligned. The LED will light and display the Battery level for five seconds, then turn off.
2. If using a Pan Guard, place it on a flat surface. To insert the Pan Guard, angle the Blending Arm to one side of the mounting clip. Then, gently pull the other mounting clip outward and push down the Blending Arm. Ensure the Mounting Clips are secured into place.
3. Insert the Blending Arm into the handle and twist to lock. Press and hold the Unlock Button first, then the Variable Speed Controller to start. Use your free hand to cover the top of the Blender Jar for better stability and to avoid splashing. The LED will light and display the Battery level for five seconds, then turn off.
   NOTE: Do not immerse Motor Body into liquids or other mixtures.
4. Use the draw up motion with the Cordless Hand Blender to move the ingredients within the Jar. Slowly draw it upwards against the side of the Jar. Repeat the process until the ingredients are at the desired consistency.

CARE AND CLEANING

Allow the appliance to cool completely before putting on or taking off parts, and before cleaning the appliance. Make sure that the Variable Speed Controller is not pressed and the Battery is removed before attaching or removing parts or accessories.

1. Remove the Blending Arm or Pan Guard before cleaning.
2. Dishwasher-safe parts — top rack only: Pan Guard, Blender Jar, and Lid. Wash Blender Arm in hot, soapy water.
3. Wipe the Motor Body with a damp cloth. Mild dish soap may be used, but do not use abrasive cleansers.

For detailed information on the Cordless Hand Blender:
Visit www.kitchenaid.com/quickstart for additional instructions with videos, inspiring recipes, and tips on how to use and clean your Cordless Hand Blender.

PRODUCT SAFETY

IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the following:

1. Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in fire and/or serious injury.
2. To protect against risk of electrical shock, do not put the Motor Body of appliance, USB Adapter, USB Cable or Battery in water or other liquid.
3. This appliance is not intended for use by children or by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge. Close supervision is necessary when any appliance is used near children. Children should be supervised to ensure that they do not play with the appliance.
4. Remove the Battery before assembling or disassembling and before cleaning. To unplug the adapter, grasp the plug and pull from the outlet. Never pull from the power cord.
5. Avoid contacting moving parts.
6. Do not modify or attempt to repair the appliance or the Battery.
7. Do not operate any appliance or USB Adapter with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Contact KitchenAid at their customer service telephone number for information on examination, repair, or adjustment. This will ensure that the safety of the appliance and accessories is maintained.
8. The use of accessories/attachments not recommended or sold by KitchenAid may cause fire, electric shock, or injury to persons.
9. Do not let cord hang over edge of table or counter.
10. Do not let cord contact hot surfaces, including the stove.
11. Keeps hands and utensils out of the container while blending to prevent the possibility of severe injury to persons or damage to the unit. A scraper may be used but must be used only when the unit is not running.
12. Blades are sharp. Handle Carefully.
13. When mixing liquids, especially hot liquids, use a tall container or make small quantities at a time to reduce spillage.
14. To reduce the risk of injury, never place cutting blade on base without first putting bowl properly in place.
15. Be certain cover is securely locked in place before operating the appliance.
16. Do not use an extension cord. Plug the adapter directly into a power source.
17. Use only with the adapter provided with the appliance. Do not attempt to use this adapter with any other product. Likewise, do not attempt to charge this appliance with any other adapter.
18. Do not incinerate this appliance even if it is severely damaged. The batteries can explode in a fire.
19. Keep hands and utensils away from the cutting blade while chopping food to reduce the risk of severe injury to person, or damage to the appliance. A scraper may be used, but only when the appliance is not running.
20. Allow the appliance to cool completely before putting on or taking off parts, and before cleaning the appliance.
21. Refer to the "Care and Cleaning" section for instructions on cleaning the surfaces in contact with food.
22. When mixing liquids, especially hot liquids, use a tall container or make small quantities at a time to reduce spillage.
23. Disconnect the Battery from the appliance before making any adjustments, changing accessories, or storing appliance. Such preventive safety measures reduce the risk of starting the appliance accidentally.
24. Prevent unintentional starting. Ensure the switch is in the off-position before connecting to the Battery, picking up or carrying the appliance. Carrying the appliance with your finger on the switch or energizing appliance that have the switch ON invites accidents.
25. Recharge only with the adapter specified by the manufacturer. The adapter that is suitable for one type of Battery may create a risk of fire when used with another Battery.
26. Use appliances only with KitchenAid 12 V Battery. Use of any other batteries may create a risk of injury and fire.
27. When Battery is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to another. Shorting the Battery terminals together may cause burns or a fire.
28. Under abusive conditions, liquid may be ejected from the Battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help.
    Liquid ejected from the Battery may cause irritation or burns.
29. Do not use a Battery or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
30. Do not expose a Battery or appliance to fire or excessive temperature. Exposure to fire or temperature above 265°F may cause explosion.
31. Follow all charging instructions and do not charge the Battery or appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the Battery and increase the risk of fire.
32. Use only UL listed ITE/Class 2 USB source to charge this device. Use of any non-UL listed USB sources may create a risk of fire.
33. Never service damaged batteries. Service of batteries should only be performed by the manufacturer or authorized service providers.
34. Do not use the appliance in rain or wet condition. Do not expose to rain — store indoors.
35. Do not use the appliance for other than intended use.

SAVE THESE INSTRUCTIONS
This product is designed for household use only.

ELECTRICAL REQUIREMENTS
USB Adapter:
Input: 100–240 V~, 50–60 Hz, 0.5 A
USB Output: 5 VDC, 2 A
Recommended ambient charging temperature: 41-104°F
External Battery (Lithium-ion): KRB12
Nominal Voltage: 10.8 VDC
Maximum Voltage: 12 VDC
NOTE: If the adapter does not fit in the power source, contact a qualified electrician. Do not modify the adapter in any way.
Do not use, store, or charge Battery or products in locations where the temperature is less than 50°F or more than 104°F.