1.4.3 Bottom Panel
The following graphic displays the rear panel of the GPON Device.
Figure 3 Bottom Panel
The following table describes the items on the bottom panel.
Table 2 Rear Panel Ports
LABEL
PON
LAN
RESET
POWER
1.5 The Reset Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button at the back of the GPON Device to reload the factory-default configuration file. This means that
you will lose all custom configuration and the password will be reset to the default.
1.5.1 Using the Reset Button
Make sure the POWER LED is on (not blinking).
1
To set the GPON Device back to the factory default settings (LAN IP address 192.168.1.1, user name
2
admin and password 1234), press the RESET button for more than three seconds and then release it. The
LEDs flash and the GPON Device restores the defaults and restarts.
Chapter 1 Introduction
DESCRIPTION
Connect a fiber optic cable to the PON port for Internet Access.
Connect a computer or another Ethernet device to the LAN port for Internet access.
Press the button to return the GPON Device to the factory defaults.
Connect the power cable (12V 0.5A) can press the ON/OFF button to start the
device.
PMG1005-T20B User's Guide
8