Table of Contents
Advertisement
Winch 10 - Cheat Sheet
MODE functions:
MODE 1
MODE 2.
MODE 7
MODE 8
MODE 3, 4, 5, 6
DMX channels:
DMX channel 1
DMX channel 2
DMX channel 3
DMX channel 4
DMX channel 5
DMX channel 6
DMX channel 7
How to get started.
1:
Place / Rig the winch in something high with minimum 2-3 meter below.
2:
Put on counterweight on the winch hock, minimum 1 kilo.
3:
Set the DMX start address to 001, and the MODE to 2.
4:
Apply DMX from a Lighting desk, best is a desk with manual faders.
Make sure that your 7 channels are patched from DMX channel 1 to 7.
Pull all channels to 0%
5:
Apply power to the winch.
DMX lamp should be lit, and the mode lamp should be flashing.
6:
Pull channel 6 to 20 % -- the winch starts pulling the wire
Stop (pull channel 6 to 0%) when the wire is at the top position ( pulled into the winch )
NOW the winch has found its TOP position and is ready to drive with position
control.
7:
Pull channel 1 (position) to 95 %
Pull channel 3 (speed) to 20%
Now the winch start to move down, with 20% speed, to a position the is 95%
up.
8:
Pull channel 1 (position) to 80%
Now the winch starts to move down, with 20% speed, to a position that is 80%
up.
9:
Pull channel 1 (position) to 90 %
Pull channel 3 (speed) to 50%
The Winch starts to move UP again, with 50% speed, and stops 1 meter before
the top.
805.241.009
Date: October 14, 2016
Positioning with auto TOP reset.
Positioning with manual top reset ( factory setting )
Manual run up (no DMX needed).
Manual run down (no DMX needed).
Only if specified, otherwise the motor stops.
Position rough. (Hi of a 16 bit DMX channel).
Position fine. (Lo of a 16 bit DMX channel).
Max speed.
Max travel top.
Max travel bottom.
Find TOP position, moving UP
Moving DOWN
18
Advertisement
Table of Contents
