Wahlberg Winch 10 Cable Cheat Sheet

Winch10 Cable - Cheat Sheet
MODE Functions
0 Neutral function – motor stops
1 Positioning with auto TOP reset
2 Positioning with manual TOP reset
3,4,5,6 Stops the motor unless specified otherwise
7 Manual run up (DMX address = speed)
8 Manual run down (DMX address = speed)
9 Used for re-calibrating overload
Intact cable
Broken cable
Inspection points
AXEL GRUHNS VEJ 3, 8270 HØJBJERG, DENMARK
213.806.008
DMX ch.
1
2
3
4
5
6
7

Before each use

− Check that the winch is safely and correct installed/mounted.
− Inspect the entire length of the lifting cable for bends,
damage, wear, broken or cut cord, and abuse.
− Inspect the cable lock and thimble for damage, wear,
corrosion, or abuse.
− Secure that the load is safely attached and weighs max 10 kg.
− Check all limit switches.
− Check the slack detection device
Warning! Do not use the winch if any damage or error is found!
· WWW.WAHLBERG.DK
Function
Position rough (Hi of a 16 bit DMX channel)
Position fine (Lo of a 16 bit DMX channel)
Set the maximum speed
Set the soft TOP limit
Set the soft BOTTOM limit
Find hard TOP limit, moving up (reset speed)
Moving down
· TELEPHONE +45 86 18 14 20
Date: 2017-10-24