Table of Contents
Advertisement
Connecting:
Power:
The winch is connected to 230VAC, by the enclosed Powercon plug.
When the power is correctly connected, the green lamps on the winch are
blinking.
DMX:
DMX is connected by the 5 poled XLR plug on the front of the winch (DMX IN).
The DMX lamp will glow constant, when the connection is correct.
Settings:
DMX address:
The DMX address is set on the 3 DMX-selectors on the front of the winch.
The selected DMX address states from which channels, on the
lighting desk, the winch is controlled.
The DMX address can be selected from 1 – 505.
The winch uses 7 DMX channels in total.
MODE:
The wanted MODE function is set on the MODE-selector on the side of the winch.
Each MODE states a certain function. (See under MODE functions).
Lamps:
DMX lamp:
The DMX lamp is the green led, next to the DMX-selectors.
The DMX lamp will glow constant if the DMX signal is
connected correctly.
The DMX lamp will flash if the DMX signal is missing or
wrongly connected.
Position lamp:
The position lamp is the green led, next to the MODE-selector.
The position lamp indicates, by fast flashing, that the winch needs to be reset, before it can
be used.
The positions lamp indicates, by slow flashing, that the winch has been reset and that it is
going towards the wanted position.
The position lamp indicates, by stable light, that the winch has found the wanted position and
the motor has stopped.
805.241.009
Date: October 14, 2016
8
Advertisement
Table of Contents
