Table of Contents
Advertisement
Medium Roll Down – Cheat Sheet
MODE
Function
1
Positioning with slow ramp
2
Positioning with medium ramp
3
Positioning with fast ramp
4
Positioning with slow ramp hard-limits active
5
Positioning with medium ramp hard-limits active
6
Positioning with fast ramp hard-limits active
7
Set soft top and bottom limits using the control box
8
Run to top or bottom position using the control box
9
Manual up (DMX address = speed)
0
Manual down (DMX address = speed)
WARNING!
Do not use the product
if any damage is found!
How to get started
1. Put on fabric/curtain on the tube/drum.
2. Apply DMX from a Lighting desk, ideally a desk with manual faders.
3. Make sure that your six channels are patched from DMX channel 1 to 6.
4. Pull all channels on to 0%
5. Apply power to the product and set the address to 0 0 1 and the mode to 1 -
6. Set DMX channel 4 to 63% -
Pull channel 5 to 20 % -- the drum starts moving up.
7.
8.
Stop the drum (pull channel 5 to 0%) when the desired top position is reached.
Pull channel 6 to 20 % -- the drum starts moving down.
9.
10. Stop the drum (pull channel 6 to 0%) when the desired bottom position is reached.
11. Pull channel 1 (position) to 75 %
12. Pull channel 3 (speed) to 50% -
13. Pull channel 1 (position) to 25% - T
Green LED indicators:
LED next to the DMX-selectors.
Glows constant:
DMX connection is correct.
Flashing:
DMX signal is missing.
LED next to the DMX-selectors.
Fast flashing:
The roll down needs to be reset, before it can be used.
Slow flashing:
The roll down's is moving towards the set position
Steady light:
The set position has been reached and the motor stopped.
239.805.001
Before each use
− Inspect the Product for damage, wear, corrosion or abuse.
− Inspect the fabric/curtain attachment for damage, wear, corrosion or abuse
and secure the fabric/curtain is safely attached and within maximum weight.
− Check that the Product is securely mounted according to the user manual.
This enables the saving of soft-limit top and bottom position.
The drum starts to move up, with 50% speed, to a position that is 75% up.
he drum starts to move down, with 50% speed, to a position that is 25% up.
DMX
channel
1
Position rough (Hi of a 16-bit DMX channel)
2
Position fine (Lo of a 16-bit DMX channel)
3
Set the maximum speed
4
60-65%
Else
5
Set soft-limit TOP position, moving up
6
Set soft-limit BOTTOM position, moving down
DMX lamp should be lit.
Tech specs:
Lifting speed
Maximum load
Control box and Hard-limit switch - XLR 4 pole
Pin 1 - GND (COM/switch return)
Pin 2 - Down (CCW) control NO / CW (Up) hard-limit NC
Pin 3 - Up (CW) control NO / CCW (Down) hard-limit NC
Pin 4 - +5VDC output (optional)
24
Function
Save setting
Enabled
Save setting
Disabled
1,7-38 cm/s
(0.6-15 in/s)
20 kg (44.1 lb)
Date: 2020-03-11
Advertisement
Table of Contents
