Drain Hose External; Drain Hose Internal - GE GTW750CPLDG Technical Service Manual

6. Pull the pump away from the tub. Be sure the
The seal comes with a new pump, but can be
ordered separately (Part #: WH08X24179).

Drain Hose External

The drain hose is used to direct the water being
expelled from the tub by the drain pump to the
house drain or standpipe.
Drain Hose Removal
Ensure that the washer tub is empty before
removing the drain hose.
1. Squeeze the spring clamp and slide it up onto
the drain hose part where it clamps to the
drain port and then remove the hose.

Drain Hose Internal

The internal drain hose is used to direct the water
being removed by the drain pump to the external
drain hose.
Internal Drain Hose Removal
Ensure the washer tub is empty before removing
the drain hose. The internal drain hose clamp
can be reached two ways; either through the rear
access panel, or by leaning the washer back.
1. Access the rear of the washer and remove
Pump Seal
the external drain hose. Have a towel or small
pan ready to catch excess water from the
hose and tub.
2. Remove the 1/4 in. hex head screw securing
the drain port to the access panel.
3. Push in on the locking tab and slide the drain
port up and to the inside of the cabinet.
4. Squeeze the spring clamp and slide onto the
drain hose where it clamps to the drain pump,
then remove the hose.
Drain
Drain
hose
Hose
Drain
Drain
port
Port
Clamp Clamp
– 52 –
Screw
Internal
Drain
Hose
Locking Tab