GE GTW750CPLDG Technical Service Manual page 14

G
Individual settings for agitation (Soil), water temperature (Temp), and spin (Spin) can be set
from the minimum (lowest in column) to maximum (highest in column). In general, the higher
up the column, the more washer energy will be used.
Longer spin times typically reduce dryer time/energy usage (i.e.: reduces total
energy when using both a washer and a dryer).
Cycle Options
H
Deep Fill
Select the Deep Fill feature for loads where extra water is needed. The Deep Fill feature is
recommended for special caseloads only, not for typical use.
Press the Deep Fill button once before starting the cycle to add an incremental amount of
water to the wash load. Holding the Deep Fill button for 3 seconds will provide the deepest
washer.
To cancel the option if desired, press the Deep Fill button again.
The
Deep Fill
button again and the water will stop.
Warm Rinse
Auto Soak
through the rest of the cycle automatically. Repeated pressing of the Soak button will scroll
through 15 minute, 30 minute, 1 hour and 2 hour selections and then return back to 0 soak
minutes.
Deep Rinse
Set this option to provide a deep rinse or when using fabric softener. It may change other
settings (e.g.: Spin may go to a higher setting) to maximize performance.
Delay Wash
When the Delay Wash button is repeatedly pressed, the delay time is set from 1 (01H) to
9 (09H) hours and back to clear (00H) hours. Press and hold the Delay Wash button for 3
seconds to immediately reset.
Extra Rinse
When using extra detergent or bleach to clean heavily soiled clothes, use the Extra Rinse
option to better remove additional residues. NOTE: This option is not allowed for some
cycles.
(Continued next page)
– 14 –