Table of Contents
Advertisement
OPERATING COMPONENTS WITH REMOTE CONTROL
1
Enter the setup code for each component
other than this receiver you wish to
control. For details, refer to "Entering a
setup code" on page 16.
2
Turn on the component you want to
operate.
3
Press the DEVICE button on the remote
control corresponding to the component
you wish to operate.
4
Aim the remote control at the REMOTE
SENSOR of the component you wish to
control and press the button corresponding
to the operation you want.
• When operating a Sherwood CD player or tape deck
using digi link system remote control, aim the remote
control at the REMOTE SENSOR of this receiver.
However, to operate a Sherwood DVD player, aim at
the REMOTE SENSOR of the corresponding
component.
LOADING BATTERIES
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within
several minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared.
Should this happen, you should memorize them again.
1
Remove the cover.
REMOTE CONTROL OPERATION RANGE
• Use the remote control unit within a range of
about 7 meters (23 feet) and angles of up to 30
degrees aiming at the remote sensor.
POWER
REMOTE
SENSOR
ON/
OFF
INPUT SELECTOR
STANDBY
AUDIO
VIDEO
7CH DIRECT
AUTO
ON/STANDBY
PHONES
CHANNEL
SPEAKER
DYNAMIC
SPEAKER
SELECTOR
ADJUST
TONE MODE
SETUP
RANGE
ON/OFF
7m
T/V
T/V
1
2
3
4
5
6
7
8
9
0
+10
+10
MACRO
MACRO
M1
M1
M2
M2
M3
M3
2
Load two batteries("AAA" size) matching
the polarity.
• Remove the batteries when they are not used for a
long time.
• Do not use the rechargeable batteries(Ni-Cd type).
• Be sure to use alkaline batteries.
15
MASTER VOLUME
EON PTY
EON TA
SEARCH
DISPLAY
PTY SELECT
SURROUND MODE
PL
II
MUSIC
DIGITAL
DSP MODE
STEREO
PARAMETER
INPUTS
VIDEO 3
CINEMA EQ
MEMO/ENTER
TUNING/PRESET
T/P MODE
FM MODE
BAND
VIDEO
L - AUDIO - R
Hide quick links:
Advertisement
Table of Contents
