Operating Components With Remote Control; Remote Control Operation Range; Loading Batteries - Sherwood Newcastle R-872 Operating Instructions Manual

OPERATING COMPONENTS WITH REMOTE CONTROL

1.
Enter the setup code for each component other
than this receiver. For details, refer to "Entering
a setup code" on page 21.
2.
Turn on the component you want to operate.
3.
Press the DEVICE button on the remote control
corresponding to the component you wish to
operate.
4.
Aim the remote control at the REMOTE
SENSOR of the component you wish to control
and press the button corresponding to the
operation you want.
Notes :
• When you cannot operate any component, check if the
transmission signal mode is set to "RF". (For details,
refer to "Changing the transmission signal" on page 29.)
• In this case, to operate the component, connect the IR
emitter to the IR OUT jack and use the remote control
toward this receiver. (For details, refer to "CONNECTING
RF REMOTE ANTENNA" and "CONNECTING MULTI-
ROOM SYSTEM KIT" on page 14.)

LOADING BATTERIES

When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries
•
within several minutes after removing old batteries.
If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be
•
cleared. Should this happen, you should memorize them again.
1.
Remove the cover.

REMOTE CONTROL OPERATION RANGE

In case that this remote control emits the infrared beams
• Use the remote control within a range of about 7 meters
(23 feet) and angles of up to 30 degrees aiming at the
remote sensor.
In case that this remote control emits the RF beams
• Use the remote control within a distance of about 15 meters
(50 feet) toward this receiver.
2.
Load four alkaline batteries ("AAA" size, 1.5V)
matching the polarity.
• Remove the batteries when they are not used for a
long time.
• Do not use the rechargeable batteries (Ni-Cd type).
• Be sure to use alkaline batteries.
20