Enjoying Surround Sound - Sherwood R-765 Operating Instructions Manual

ENJOYING SURROUND SOUND

Depending on the input digital signal format, select the desired decoding mode.
1
SURROUND MO
AUTO
or
Notes :
• Only when the digital input is selected as signal input for the input sources except TUNER, TAPE and AUX, the
decoding mode can be selected.
• Noise may be generated at the beginning of playback and while searching during DTS playback in the IN-AUTO
mode. In this case, try playing in the IN-DTS mode.
Select the desired surround mode.
2
SURROUND MODE
• Each time the DSP MODE (<) or
format and the selected decoding mode as follows :
Signal format being input
Dolby Digital EX 6.1 channel sources
Dolby Digital 5.1 channel sources
Dolby Digital 2-channel
sources
PCM(2 channel) sources
Analog stereo sources
DTS sources
• When the analog input is selected as signal input and analog stereo signals are input, you can select the desired of
these above surround modes, too.
• However, when DTS signals are input in the IN-AUTO or IN-DTS mode, the corresponding DTS mode will be
selected regardless of using the DSP MODE
Notes:
• When the selected decoding mode is not matched to the input signal format, the "DIGITAL" indicator flickers and
no sound is heard. Therefore, be sure to select the required decoding mode and the available surround mode
according to the input signal format.
• When the 7 CH DIRECT is selected as an input source, the decoding and surround modes cannot be selected.
• When the digital signals are not inputted, the desired surround mode cannot be selected.
T/V
• Each time the AUTO button is pressed, the decoding
mode changes as follows :
IN-AUTO : The input digital signal format(DTS, Dolby
AUTO
IN-DTS : The DTS signal processing is performed only
2 3 4
1
5 6 7 8 IN-PCM : The PCM signal processing is performed only
9 0
+10
MACRO
M1 M2 M3
DSP MODE
or
(>) button is pressed, the surround mode changes depending on the input signal
Selected decoding mode
IN-AUTO mode
IN-AUTO mode
IN-AUTO mode
IN-AUTO, IN-PCM mode
IN-AUTO, IN-DTS mode
(<) or (>) button.
27
T/V
Digital or PCM(2 channel stereo), etc.) used
by the selected digital input source is detected
automatically to perform the necessary
decoding process for optimum surround mode.
2 3 4
1
when DTS signals are input.
5 6 7 8
when PCM signals are input.
T/V
9 0
+10
MACRO
M1 M2 M3
DSP <, >
1 2 3 4
5 6 7 8
9 0 +10
MACRO
Selectable surround mode
M1 M2 M3
DOLBY DIGITAL EX, DOLBY VIRTUAL
DOLBY DIGITAL, DOLBY VIRTUAL
PL II MOVIE, PL II MUSIC,
PRO LOGIC, DOLBY VIRTUAL
PL II MOVIE, PL II MUSIC, PRO LOGIC,
DOLBY VIRTUAL, NEO 6 CINEMA, NEO 6
MUSIC, THEATER, HALL, MATRIX
corresponding DTS mode
T/V
1 2 3 4
5 6 7 8
9 0 +10
MACRO
M1 M2 M3