Plantronics CA12CD-S/A User Manual

Audio Link
LED button
Listen
Fine-Adjust
Switch
Quick Disconnect™ Battery
for Headset Pack
See Note 3.1
REMOTE UNIT
USER GUIDE
CA12CD-S/A
Model
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Push-to-Talk Headset Amplifier
SPARE
CHARGE
TALK
VOLUME
BASE
POWER
COMPONENTS OF MODEL CA12CD-S/A
Setup and operation
Charging well for
spare battery pack
Plug Console
Push-to-
AC adapter
Interface Cable
Talk
in here
button
Subscription
button
BACK VIEW OF BASE UNIT 1.1, 1.2
1.1 Plug the modular connector on the Console Interface Cable into the
modular jack on the back of the Base. Plug the other end into your
console.
1.2 Plug the AC adapter into a wall outlet, and plug the
power connector into the back of the Base. The
Base Power LED will turn on.
Momentary/
1.3 Slide the battery pack onto the Remote and snap it
locking PTT
into place without forcing it. The CA12CD-S/A will
selector
take a few seconds to select the most reliable radio
(not shown;
channel, and then it will start to blink its Audio Link
see Fig. 1.7 and
LED at once per second, to indicate that it is ready
Note 4.1)
to use.
1.4 For first-time use, press the Audio Link button to
turn the audio link off, and place the Remote into its
charging well to charge the attached battery pack.
1.5 Place the spare battery pack into its charging well.
1.6 The Charge LEDs will flash until the battery packs
are fully charged, at which time the LEDs will
stop flashing and remain on. (It is okay to use the
Remote after only one hour of charging time if
desired.)
1.7 Press the PTT Button on the Remote to key up your
REMOTE
CHARGE
TALK
Plug AC
Adapter
in here
SPARE
CHARGE
TALK
VOLUME
BASE
POWER
Spare
battery pack
Talk Volume
Charge LED
buttons
(orange)
(fine-adjust) See
Note 4.1
Base Unit power
LED (green)
BASE UNIT
Installing the battery pack
Audio Link
LED button
Listen
Fine-Adjust
Switch
Quick Disconnect™
for Headset
Console
Interface Cable
2.1 Careful setting of the audio lev
console and in the CA12CD-S/A
quality and avoiding echo. Plea
Settings Guide for the CA12CD
2.2 Operating other radio devices,
in the same frequency band as
Charging well for
number of units that can be op
remote unit
reducing their maximum range
DECT frequency band (1.88 to
Remote Unit
2.3 User density and range can var
Battery Charge LED
building layout and whether ot
(orange)
same frequency band as the CA
PTT LED
REMOTE
In low-density installations (e.g
CHARGE
(green)
range can be greater than 100
(e.g., 30 units placed 18 inches
TALK
as little as 10 feet. In general, it
from each other as possible.
2.4 Keep mobile phones at least 3
Remote when the Remote is no
Remote are near each other, m
feet, but should never be place
2.5 Remove the battery pack and p
to allow more radio spectrum f
important where large number
BOTTOM VIEW
OF BASE UNIT
1.3
C
Battery
Pack
See Note 3.1
REMOT
Performance tips
Talk
Coarse-Adjust
Switch
Listen
Coarse-Adjust
Switch
Battery charging
and management