Download Print this page
Subaru Remote Start Quick Reference Instruction Manual

Subaru Remote Start Quick Reference Instruction Manual

Advertisement

Quick Links

REMOTE START QUICK REFERENCE*
Press
Two (2) Times
Within Three (3) Seconds
Remote Start
Activation
NOTE: All vehicle doors, hood, trunk or rear gate must be closed prior to activating the remote engine start
system. Any open entry point will prevent starting or cause the system to shut down.
Upon successful activation, the remote start transmitter will fl ash and beep one (1) time**, the horn will honk one (1)
time and the side marker lights, tail lights and parking lights will fl ash one (1) time. The system will check certain
safety preconditions before starting and if all conditions are met, the engine will start within fi ve (5) seconds. After
the engine starts, the remote start transmitter will fl ash and beep two (2) times**, the horn will honk one (1) time and
the side marker lights, tail lights and parking lights will fl ash one (1) time. While the engine is running via the remote
engine start system, the remote start transmitter will continue to fl ash one (1) time every three (3) seconds, the side
marker lights, tail lights and parking lights will remain illuminated and the power window switches will be disabled. The
engine will continue to run for fi fteen (15) minutes unless one of the safety parameters below is triggered. The system
also has a timer that will allow the system to operate for a maximum of twenty (20) minutes (under multiple remote
start activations). Using the factory ignition key (Turn start models) or Access key (Push start models) to turn on the
ignition resets the twenty (20) minute timer.
If the engine turns over but does not start (or starts and stalls) the remote engine start system will power off and then
attempt to start the engine three (3) additional times. The system will not attempt to restart the engine if it determines
a vehicle malfunction is preventing it from starting. If the engine does not start after the three (3) additional attempts,
the remote engine start request will be aborted.
Remote Start Safety Parameters
For safety and security reasons, the system will fail to start or shut down the engine during remote start operation if
any of the following occur:
The remote start system has operated for twenty (20) minutes between ignition "ON" cycles
The horn will honk three (3) times and the parking lights will fl ash three (3) times
Any of the vehicle's doors, trunk or rear gate are open
The horn will honk six (6) times and the parking lights will fl ash six (6) times
The vehicle's hood is open
The horn will honk two (2) times and the parking lights will fl ash two (2) times
The ignition key is resting in the ignition cylinder (Turn start models)
The horn will honk two (2) times and the parking lights will fl ash two (2) times
The transmission shifter is not in the "park" position
The horn will honk two (2) times and the parking lights will fl ash two (2) times
The vehicle's brake pedal is pressed before the vehicle ignition is turned "ON"
The horn will honk two (2) times and the parking lights will fl ash two (2) times
The vehicle's engine idle speed has reached a level over 3,500 RPM (this will cause the vehicle to shutdown)
The vehicle's security system is triggered by opening the door or rear gate (if the security system is armed at the
time of remote start activation)
In addition to the items above, if the vehicle's engine management system determines there is a safety risk due to a
vehicle related problem, the engine will shut down.
WARNING: TO AVOID DANGER OF CARBON MONOXIDE, NEVER REMOTE START A VEHICLE IN A CLOSED
SPACE SUCH AS A CLOSED GARAGE.
NOTE: Laws in some communities require that the vehicle be within view of anyone using the Remote Engine
Start. In some areas, use of the Remote Engine Start may violate state, provincial or local laws. Before using
the Remote Engine Start, check your state, provincial and local laws.
* See the vehicle owner's manual for more details.
** Provided that the remote start transmitter is within the operating range of the system.
Press and Hold
For Two (2) Seconds
Remote Start
Shutdown
P/N: 4280648, Rev P2

Advertisement

loading

Summary of Contents for Subaru Remote Start

  • Page 1 fi ve (5) seconds. After the engine starts, the remote start transmitter will fl ash and beep two (2) times**, the horn will honk one (1) time and the side marker lights, tail lights and parking lights will fl...
  • Page 2 (if the security system is armed prior to activating the remote start system) and the engine will turn off. Turning on the ignition or pressing the unlock button on the remote keyless entry transmitter will disarm the security system.