Nokia MetroHopper User Manual page 27

Figure 2.
3.
4.
5.
Note
The status of the hop will not be Ready before also the other end of the hop is
commissioned successfully. Thus, the status of the terminal that is commissioned
first will have the status Commissioning until the far-end terminal is
commissioned.
12 (42) © Nokia Networks Oy
MetroHopper General Settings page
If the transmission unit in use is FXC RRI, define the settings for the
Flexbus interface 2 and the connected outdoor unit as described above. If
the transmission unit is FC RRI, only one Flexbus is available and you can
proceed to step 4 directly.
When you have entered all the required settings, Summary of
Commissioning Settings page is displayed. It contains all the settings you
have defined for the radio(s). Check that the settings are correct and click
Next to send the settings to the node. You can also go back in case you want
to adjust the settings on previous pages.
Monitoring Hop page displays the status of the hops during and after the
commissioning. If the commissioning is successful, the status becomes
Ready.
Commissioning and Maintenance
DN99611394
Issue 2-0 en