Task List - Nokia MetroHopper User Manual

•
•
•
•
3.3

Task list

Plan the work in advance. The following work order is recommended for the
installation of the Nokia MetroHopper outdoor unit:
Prepare the cabling beforehand so that the cables can be connected to the outdoor
unit immediately after it has been installed.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
12 (26) © Nokia Networks Oy
protective clothing, helmet
drill in case of wall installation
two suitable wall bolts in case of wall installation
DC voltage meter and a cable with BNC connector in case the alignment is
done with AGC voltage measurement.
Mount the alignment bracket (see 4.1 and 4.2)
Attach the optical alignment tool (see 4.3).
Perform the coarse alignment (pre-alignment) (see 4.4).
Perform the fine alignment (see 4.5).
Finish the alignment (see 4.6).
Attach the radio section (see 4.7).
Connect the grounding wire (see 5.1).
Connect the Flexbus cable (see 5.2).
Connect the synchronisation cable, if needed (see 5.3).
Close the connector cover (see 5.4).
Installation
DN99592289
Issue 2-1 en