Connecting The Synchronisation Cable; Closing The Connector Cover - Nokia MetroHopper User Manual

To connect the IU - OU Flexbus cable:
1.
2.
If the Flexbus cable is taken to the radio but left unplugged, protect the connector.
Ground the sheath of the Flexbus cable between the indoor unit and the outdoor
unit at approximately 50 m intervals. Ground the sheath also at the inlet to the
equipment space. National regulations may require grounding every 20 m.
5.3

Connecting the synchronisation cable

If synchronisation is required, remove the connector cap and connect the
synchronisation cable to Sync-connector. See Product Description for further
details on planning the synchronisation.
5.4

Closing the connector cover

After connecting all the required cables, close the connector cover and tighten the
screw.
DN99592289 © Nokia Networks Oy
Issue 2-1 en
Connect the TNC connector of the Flexbus cable to the FB+ interface.
Tighten theconnector manually (0.5 Nm).
Tie the cable to the installation pole with cable ties or with special holders
(FIMO, for example).
Connecting interfaces
25 (26)