Nokia MetroHopper User Manual page 26

Figure 1.
2.
DN99611394 © Nokia Networks Oy
Issue 2-0 en
Flexbus settings page
The MetroHopper General Settings page is displayed next. On this page,
you can select the settings for the outdoor unit connected to the Flexbus 1
interface.
• Hop Mode: one of the terminals forming a radio hop must be
configured as the master and the other end as the slave. The
hierarchy is decided in the network planning phase.
• Temporary Hop ID: the master and the slave must have the same
temporary hop ID. When the commissioning is completed, this is
automatically changed to a unique hop ID.
• Channel Selection: you can choose either Manual or Automatic
channel selection. When you click Next, the corresponding channel
selection page will open.
• If you choose Manual channel selection, select the desired
channel. You can also click Measure to measure the
interference level on the selected channels and then select the
best available channel.
• If you choose Automatic channel selection, mark the channels
among which the channel is to be selected. The software
automatically measures the interference levels on each
channel, and selects the best one.
Commissioning Nokia MetroHopper
11 (42)