Compact Disc Operation - Sharp MD-MX20 Operation Manual

COMPACT DISC OPERATION

CD playback
1
3" (8 cm)
1
3,5
6
2
Label side up
4
5" (12 cm)
6
2
13
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Press the 7 7 7 7 7 button to open the disc tray.
4
Place the CD on the disc tray, label side up.
Be sure to place 3" (8 cm) CD in the middle of the disc
tray.
5
Press the 7 7 7 7 7 button to close the disc tray.
The total number of tracks and the total playing time will
be displayed.
Total number of tracks
6
Press the CD 06 06 button to start playback from track 1.
06 06
06
When the last track has been played back, the unit will
stop automatically.
To interrupt playback:
Press the CD 06 button.
" 6 " will appear.
Press the CD 06 button again to resume playback from
the same point.
To stop playback:
Press the CD button.
To remove the CD.
Press the 7 7 7 7 7 button.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Caution:
Do not carry the unit with a CD left in the disc tray. The
disc may come loose inside the unit and it may be dam-
aged or cause damage to the unit. This may also cause
malfunctions.
Do not push the disc tray while it is moving.
If the power fails while the tray is open, wait until the power
is restored.
If the disc tray is stopped forcibly, "E-CD20" will appear in
the display and the unit will not function.
If this occurs, press the ON/STAND-BY button to enter the
stand-by mode and then turn the power on again.
Subjecting the unit to shock or vibration may cause mistracking.
Playing certain CDs at a high volume may cause mistracking.
In this case, listen at a lower volume.
If TV or radio interference occurs during CD operation, move
the unit away from the TV or radio.
Total playing time