Sharp MD-MX20 Operation Manual page 26

(Continued)
Recording from the built-in radio onto a
MiniDisc
2
4
3
5
MD
3
1
Tune in to the desired station (pages 19 - 20).
2
Load a recordable MiniDisc.
3
Press the REC button.
The unit will enter the recording stand-by mode.
4
Check the recordable time by pressing the DISPLAY
button.
Notes:
Before recording an AM broadcast, enter the recording
stand-by mode, and then separate the AM loop antenna
from the main unit. Adjust it so that the AM broadcast can
be tuned in most clearly.
During recording, you cannot change the station.
5
Press the MD 06 06 button.
06 06 06
5
MD
4
25
To stop recording:
Press the MD button.
The recording will stop and the track number will be written
on the MiniDisc.
To record the track number while recording:
The recording is performed as a single track.
To identify different sections of a recording, you can increase
the track number at any point during the recording process.
To create a new track number while in the recording mode,
press the REC button.
The track number will increase by one, and then the re-
cording will continue.