Error Messages - Sharp MD-M2H Operation Manual

ERROR MESSAGES

When an error message is displayed, proceed as follows:
Error messages
BLANK MD Nothing is recorded.
CAN'T EDIT
A track cannot be edited.
CAN'T REC
Recording cannot be performed correctly
due to vibration or shock in the unit.
Timer recording is impossible or there is no
available space on the MD.
CD NO DISC
A CD has not been loaded.
The disc data cannot be read.
DISC FULL The disc is out of recording space.
FOCUS ERR A disc has not been loaded.
The disc data cannot be read.
MD ERR
Trouble is found.
MD NO DISC
A MiniDisc has not been loaded.
The disc data cannot be read.
MECHA ERR* There is a mechanical problem and the disc
(*:Number or is not working properly.
symbol)
NAME FULL
The number of characters for the disc name
or track name exceeds 40.
NOT AUDIO
The data recorded on this disc is not audio
data.
PLAY MD You tried to record on a playback-only disc.
PROTECTED The disc is write protected.
READ ERR The disc is damaged.
A TOC is not written on the MD or there is
something wrong with data.
TEMP OVER
The temperature is too high.
TOC ERR*
The disc is damaged.
(*:Number or
TOC information cannot be read.
symbol)
MD not specified.
There is no space left for recording charac-
TOC FULL*
ter information (track names, disc names,
(*:Number or
etc.).
symbol)
TOC W ERR
Recording is impossible.
U TOC ERR*
TOC information recorded on the MD does
(*:Number or
not match the MD specifications or it can-
symbol)
not be read.
U TOC ERR W
The TOC information could not be created
properly due to a mechanical shock or to
scratches on the disc.
? DISC
The data contains an error.
00:00
Music is not being recorded.
Meaning
47
Remedy
Replace it with another disc.
Change the stop position of the track and
then try editing it.
Re-record or replace the MiniDisc.
Replace it with another disc.
Load a CD.
Reload the CD.
Replace the disc with another recordable
disc.
Reload the MiniDisc.
Contact the shop where you purchased the
unit.
Load a MiniDisc.
Reload the MiniDisc.
Set this unit to the stand-by mode and press
the MD EJECT button.
Shorten the disc or track name.
Select another track.
Replace the disc.
Replace it with another recordable disc.
Move the write protection tab back to its
original position.
Reload the disc or replace it.
Set this unit to the stand-by mode and wait
for a while.
Replace it with another disc.
Replace it with another recordable disc.
Contact the shop where you purchased the
unit.
Replace it with another disc.
Erase the disc and try recording again.
Set this unit to the stand-by mode and try to
write the TOC again. (Remove any source
of shock or vibration whilst writing.)
Replace it with another disc.
Replace the disc with another recordable
disc.