Advertisement
Steps to Install and Program the NETCOM6P...cont'd
32. Place a jumper ON J4 on the CIM unit to enable the board for network
communication. This designates it as CIM 0.
33. Momentarily place a jumper on the CIM board's J1 RESET pins to initiate the jumper
change in the preceding step.
34. At the PC/laptop, click on the OK button in the Disconnect the serial cable... screen.
35. Go to the next set of instructions—Set the IP Address on Control Board on page 14.
Keyscan Inc. A Member of the Kaba Group
10
Advertisement
Need help?
Do you have a question about the NETCOM6P and is the answer not in the manual?
Questions and answers