Table of Contents
Advertisement
DRAINING
Switch the electricity supply OFF at the control panel and
at the system's main switch before starting to drain the
boiler or storage cylinder.
DRAINING THE CENTRAL HEATING SYSTEM
− Make sure that the CH system fill cock (2) is clo-
sed.
− Close the shut-off cocks for the central heating
and domestic hot water circuits.
− Connect a hose to the hose union on the drain
cock (4) and open the cock.
− Close the drain cock (4) once the circuit is empty.
DRAINING THE STORAGE CYLINDER
− Close the shut-off cocks for the central heating
and domestic hot water circuits.
− Make sure that the CH system fill cock (2) is clo-
sed.
− Connect a hose to the storage cylinder drain cock
(3) and open the cock.
− Close the drain cock (3) once the circuit is empty.
NOTE!
Open a hot water tap to facilitate draining of the storage
cylinder.
DRAINING THE SOLAR HEATING CIRCUIT
− Open the non-return valve (9) to facilitate drai-
ning. See the figure to ascertain the correct posi-
tion for the dot on the screw.
− Open the manual bleed valves on the system
bleed manifold.
− Connect a hose between the container you are
using to collect the water-glycol mix and the
drain cock (B) on the valve group (11). Open the
drain cock and wait until all the water-glycol mix
has drained out of the system.
− Set the non-return valve (9) to automatic fun-
ctioning. See the figure to ascertain the correct
position for the dot on the screw.
− Close the previously opened manual bleed valves
on the system bleed manifold.
9
The drain points on the solar circuit safety valves
must also be connected to a suitable collection and
drain system.
9
The manufacturer declines all responsibility for da-
mage caused by water escaping from the safety val-
ves.
2
9
11
B
3
37
INSTALLER
4
AUTOMATIC
OPEN
Advertisement
Table of Contents
