Table of Contents
Advertisement
SOLAR CONTROLLER
Function selector
No function selected / Stand-by. (The
display shows that the system is switched on
but in stand-by mode)
Current system configuration
− The display shows a diagram of the currently
selected system configuration.
− Turn the parameter selector clockwise to di-
splay the various sensors and actuators in the
selected system configuration along with their
names (e.g. F1, F2, A1). Turn the parameter se-
lector anti-clockwise to display current statu-
ses and temperatures.
Collector/storage cylinder temperature
sensor
− The display reads out the temperature curren-
tly measured by temperature sensor F1 in the
solar collector. In some system configurations,
the temperature measured by the storage
cylinder temperature sensor is shown instead.
− The trend in temperatures measured by the
sensor over the last few hours is also shown.
Supplementary temperature sensor
− The display reads out the temperature curren-
tly measured by temperature sensor F2.
− The trend in temperatures measured by the
sensor over the last few hours is also shown.
− If temperature sensor F2 is not installed, the
display reads out the message "Not con-
nected".
F1
F3
kWh
A1
F4
F2
Esc
Escape button
Storage cylinder top temperature sensor
− The display reads out the temperature curren-
tly measured by storage cylinder top tempera-
ture sensor F3.
− The trend in temperatures measured by the
sensor over the last few hours is also shown.
− If temperature sensor F3 is not installed, the
display reads out the message "Not con-
nected".
Storage cylinder bottom temperature
sensor
− The display reads out the temperature curren-
tly measured by storage cylinder bottom tem-
perature sensor F4.
− The trend in temperatures measured by the
sensor over the last few hours is also shown.
kWh
Daily, weekly, monthly or total energy output
− The display reads out the energy produced by
the solar collector/s.
− The display switches automatically between
Wh, kWh and MWh.
User settings
− The display shows the settings the user can
change to adapt the system to his own per-
sonal needs.
Installer settings
− The display shows the setting menus the in-
staller can use to put the solar controller into
service. A password is required to access these
settings .
19
Function selector
Enter button
Parameter selector
GENERAL
Advertisement
Table of Contents
