Sharp XG-F260X Operation Manual page 53

Maintenance indicator
Normal Abnormal
Tempera-
Off
ture
(Standby)
warning
indicator
Lamp
Green on
indicator
(Green
blinks
when the
lamp is
warming
up or
turning
(Standby)
off.)
Power
Green on/
indicator
Red on
Green
blinks
(Cooling)
Info
• If the temperature warning indicator illuminates, and the projector enters standby mode, follow the
possible solutions above and then wait until the projector has cooled down completely before plug-
ging in the power cord and turning the power back on. (At least 10 minutes.)
• If the power is turned off for a brief moment due to power outage or some other cause while using
the projector, and the power supply recovers immediately after that, the lamp indicator will illumi-
nate in red and the lamp may not be lit. In this case, unplug the power cord from the AC outlet,
replace the power cord in the AC outlet and then turn the power on again.
• The cooling fan keeps the internal temperature of the projector constant and this function is con-
trolled automatically. The sound of the cooling fan may change during operation because the fan
speed may change and this is not a malfunction.
Problem
The internal
Red on
temperature is
abnormally
high.
Red on The lamp does
not illuminate.
Time to change
the lamp.
The lamp does
Red on
not illuminate.
The power
Red
indicator blinks
blinks
in red when the
projector is on.
Cause
• Blocked air intake • Relocate the projector to
• Cooling fan • Take the projector to your
breakdown
• Internal circuit
failure
• Clogged air intake
• The lamp is shut • Disconnect the power cord
down abnormally.
• Remaining lamp life • Carefully replace the lamp.
becomes 5% or
less. • Take the projector to your
• Burnt-out lamp
• Lamp circuit failure
• Please exercise care when
• Securely install the cover.
• The lamp unit cover • If the power indicator blinks
is open.
Possible Solution
an area with proper
ventilation. (See page 8.)
nearest Sharp Authorized
Projector Dealer or Service
Center (see page 64) for
repair.
from the AC outlet, and
then connect it again.
(See page 51.)
nearest Sharp Authorized
Projector Dealer or Service
Center (see page 64) for
repair.
replacing the lamp.
in red even when the lamp
unit cover is securely
installed, contact your
nearest Sharp Authorized
Projector Dealer or Service
Center (see page 64) for
advice.
49