Connecting The Projector To Other Equipment - Sharp XG-F260X Operation Manual

Connecting the Projector to Other Equipment

Before connecting, ensure that the power cord of the projector is unplugged from the AC
outlet and turn off the equipment to be connected. After making all connections, turn on the
projector and then the other pieces of equipment. When connecting a computer, ensure that
it is the last equipment to be turned on after all the connections are made.
IMPORTANT:
Ensure that the appropriate input mode has been selected on the projector before
you turn on the connected equipment.
• For more details of connection and cables, refer to the operation manual of the connecting equipment.
• You may need other cables or connectors not listed below.
Terminals on the Projector
Equipment
connected equipment
Computer
Note
• See page "Computer Compatibility Chart" for a list of computer signals compatible with the projec-
61
tor. Use with computer signals other than those listed may cause some of the functions to not work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your near-
est Macintosh Dealer.
• Depending on the computer you are using, an image may not be projected unless the
computer's external output port is switched on (e.g. Press "Fn" and "F5" keys simultaneously
when using a SHARP notebook computer). Refer to the specific instructions in your computer's
operation manual to enable your computer's external output port.
Terminal on
RGB cable (supplied)
RGB
output
terminal
mini D-sub 15 pin to DVI cable
RGB
output (commercially available)
terminal
DVI Digital cable (commercially available)
DVI digital
output
terminal
Cable
Terminal on the
projector
COMPUTER/
COMPONENT
DVI-I
21