Sharp XG-F260X Operation Manual page 21

4. Adjust the projected image with the Setup Guide
1
After the projector turns on, the Setup Guide appears.
(When "Setup Guide" is set to "On". See page 42.)
2
Follow the steps in the Setup Guide and adjust the focus, picture size, and height (angle).
3
After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup
Guide.
5. Correct trapezoidal distortion
Correcting trapezoidal distortion using Keystone Correction.
On the projector
On the remote control
6. Select the INPUT mode
Select the "COMPUTER" using INPUT on the projector or COMPUTER on the remote control.
On the On the remote
projector control
• When you press INPUT on the projector, the INPUT list appears.
Press '/" to switch the INPUT mode.
7. Turn the computer on
8. Turn the power off
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the
button again while the confirmation message is displayed to put the projector into standby mode.
On the
projector
Shrinks
upper side.
INPUT list
INPUT
COMPUTER
DVI-D Computer
D
DVI-D Video
D
On-screen display
On the remote
control
_PP. 26, 27
Shrinks
lower side.
_P. 28
On-screen display (RGB)
COMPUTER
RGB
1024 × 768
_P. 29
_P. 25
17