Starting Procedure - Hyundai HY4BC31 User Manual

6. STARTING PROCEDURE

WARNING
This machine is shipped without oil and fuel.
You MUST ensure all fluid levels are correct before operation otherwise you may
cause serious engine damage that will not be covered by the warranty.
FROM COLD
4.0 Place the machine on a flat level surface.
Turn the engine switch to the 'I' ON position.
4.1
4.2 Slowly press the primer bulb 5 to 10 times.
NOTE: After the 7
If it is not, continue to press the primer bulb until you see fuel in the bulb.
4.3 Push the choke button in, to set the choke to FULL CHOKE position.
NOTE: DO NOT squeeze the throttle trigger because the choke will pop out
and reset.
4.4 Pull the recoil starter handle until you feel resistance.
Once you feel resistance, pull the recoil starter handle swiftly 3 to 5 times or until you
hear the engine turn over or begin to start.
4.5 Allow the engine to run for 10 seconds then squeeze the throttle to release the choke
in to the RUN position.
4.6 Allow the machine to warm up for 30 seconds before use.
th
press, fuel should be visible in the primer bulb.
23