Table of Contents
Advertisement
2.36
Place the brush cutter blade so the writing on the blade faces up towards the
splined drive flange.
2.37
Ensure the raised register on the drive flange fits into the hole in the brush cutter
blade.
2.38
Place the domed washer on to the shaft so the flat surface of the washer sits
directly on to the brush cutter blade.
2.39
Placed the bump washer over the domed washer, onto the shaft as shown.
2.40
Line up the hole in the drive flange with the hole in the shaft head and lock in place
by inserting the torx wrench through the hole, wind on the shaft nut by hand.
2.41
Using the box spanner provided, tighten the shaft nut up tightly.
2.42
Remove the torx wrench.
2.43
To remove the brush cutter blade, reverse the procedure.
18
Hide quick links:
Advertisement
Table of Contents
