Daily Use - Electrolux EVY9747AAX User Manual

10 www.electrolux.com
5.2 Setting the hardness level
for the water
When you connect the appliance to the
mains, you have to set the water
hardness level.
Water hardness
Class
1
2
3
4
When the water hardness exceeds the
values in the table, fill the water drawer
with bottled water.
1. Take the four colour change strip
supplied with the steam set in the
oven.
2. Put all the reaction zones of the strip
into the water for approximately 1
second.
Do not put the strip into the running
water!
3. Shake the strip to remove the excess
of the water.
4. After 1 minute check the hardness of
the water according to the table
below.
The colours of the reaction zones
continue to change after 1 minute.
Do not consider this in the
measurement.
5. Set the hardness of the water in the
settings menu. Refer to the "Using
the settings menu".

6. DAILY USE

WARNING!
Refer to Safety chapters.
6.1 Operating the appliance
To operate the appliance you can use:
Calcium deposit
(mmol/l)
dH
0 - 7 0 - 1.3
7 - 14 1.3 - 2.5
14 - 21 2.5 - 3.8
over 21 over 3.8
The table below explains the water
hardness range with the corresponding
Calcium deposit (mmol/l) and the quality
of the water.
Calcium deposit
(mg/l)
0 - 50
50 - 100
100 - 150
over 150
Test strip
The black squares in the table
correspond to red squares on the test
strip.
You can change the hardness level of
the water in the menu settings menu.
After a power cut you do not have to set
the hardness level of the water again.
• the manual mode
• automatic programmes
Water clas‐
sification
Soft
Moderately
hard
Hard
Very hard
Hardness of the
water
1
2
3
4