Metso Jamesbury 5000 series Installation Maintenance And Operating Instructions
3 inch & 4 inch (dn 80 & 100)
flanged ball valves
Hide thumbs
Also See for Jamesbury 5000 series:
Related Manuals for Metso Jamesbury 5000 series
Summary of Contents for Metso Jamesbury 5000 series
- Page 1 3” & 4” (DN 80 & 100) SERIES 5000 FLANGED BALL VALVES Installation, Maintenance and Operating Instructions...
-
Page 2: Table Of Contents
These instructions provide information about safe handling and operation of the valve. If you require additional assistance, please contact the manufacturer or manufacturer’s representative. Addresses and phone numbers are printed on the back cover. See also www.metso.com/valves for the latest documentation. SAVE THESE INSTRUCTIONS! IMO 3/18... -
Page 3: General
Ball Valves. Please read these instructions carefully and save in real terms reduce the total cost of ownership. Metso them for further reference. recommends inspecting valves at least every five (5) years. -
Page 4: Assembly
IMO-059 EN A. Using the breechlock field wrench - assemble the 10. Remove the stem nut (15), lockwasher (33), and field wrench as follows. (Refer to Figure 1). indicator stop (12). Retain. Discard spring washers if valve is so equipped. Thread a hex nut (6A) onto the rod (3) as shown in (Figure 1). -
Page 5: Actuator Mounting
Valves sent to the service center without MSDS datasheet(s) will not be accepted. For further information on spare parts and service or assistance visit our web-site at www.metso.com/valves. NOTE: When ordering spare parts, always include the following information: Valve catalog code from identification plate, b. -
Page 6: Table Of Contents
IMO-059 EN PARTS LIST ITEM PART NAME Body Insert Stem must be centered in ball slot Ball as shown at assembly Stem Seat Body Seal Secondary Stem Seal Stem Seal Indicator Stop Socket Head Cap Screw Stem Nut Handle Cap Screw Seats must be in Compression Ring this position at assembly... - Page 7 IMO-059 EN IMO 3/18...
- Page 8 IMO-059 EN Subject to change without prior notice. Metso Flow Control Inc. Europe, Vanha Porvoontie 229, P.O. Box 304, FI-01301 Vantaa, Finland. Tel. +358 20 483 150. Fax +358 20 483 151 North America, 44 Bowditch Drive, P.O. Box 8044, Shrewsbury, M A 01545, USA. Tel. +1 508 852 0200. Fax +1 508 852 8172 South America, Av.
Need help?
Do you have a question about the Jamesbury 5000 series and is the answer not in the manual?
Questions and answers