Nautilus E614 Service Manual page 40

12. Remove the Lift Cover Shroud (S) from the Lift Assembly.
13. Using a #2 Phillips screwdriver, remove the 3 screws that
secure the Right Shroud. Remove the bottom screws first, and then
the top screw. Slowly remove the Right Shroud.
14. Installation is the reverse procedure. Put the Left Shroud in
postion first to align the screws for the Right Shroud. Install the top
screws first.
NOTICE: This step may require two people. Be sure not to
crimp any cables.
Note: Self-tapping screws attach the Shrouds to the Frame.
No screws hold the Lift Cover Shroud in position. Reach
through the left or right side opening to stabilize it while
installing the screws.
Be sure the tabs in the Top Shroud snap into the Main
Assembly.
Installation does not require the use of the crank puller. Be sure the
Crank Arms are connected at 180° from each other.
15. Dispose of the old parts.
16. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
S
40