Maintenance - Nautilus E614 Service Manual

FCC Compliance
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
The machine and power supply comply with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This machine and power supply have been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Maintenance

Read all maintenance instructions fully before you start any repair work. In some conditions, an assistant is necessary to
do the necessary tasks.
Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure that regular
maintenance is done. Worn, damaged or loose components must be repaired or replaced immediately. Only
manufacturer supplied components can be used to maintain and repair the equipment.
If at any time the Warning labels become loose, unreadable or dislodged, contact Nautilus Customer Service for
WA R N I N G
replacement labels.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the
D A N G E R
power cord from the wall outlet and wait 5 minutes before cleaning, maintaining or repairing this
machine. Place the power cord in a secure location.
AT T E N T I O N
When disposing of old parts, obey the applicable local and provincial requirements.
IMMEDIATE ACTION REQUIRED
Before each use, examine the exercise machine for loose, broken, damaged,
Daily:
C A U T I O N
or worn parts. Do not use if found in this condition. Repair or replace all parts at
the first sign of wear or damage. After each workout, use a damp cloth to wipe
your machine and Console free of moisture.
Note: Avoid excessive moisture on the Console.
Check for smooth roller operation. Wipe the machine to remove dust, dirt, or
Weekly:
grime. Clean the rails and surface of the rollers with a damp cloth.
Apply silicone lubricant to a dry cloth and wipe the rails to eliminate roller noise.
Note: Do not use petroleum based products.
Make sure all bolts and screws are tight. Tighten as necessary.
Monthly
or after 20 hours:
NOTICE: Do not clean with a petroleum based solvent or an automotive cleaner. Be sure to keep the Console free
of moisture.
4