Table of Contents
Advertisement
Converter error messages:
Directly readable at the screen after an error occurs
Error messages are displayed with an error code E01.o – E83.o on the display. The digit after the
decimal point indicates converter status at the time of error occurrence.
.0 during the initialisation process at power supply switching or a RESET signal
.1 during STOP status
.2 during braking phase
.3 during constant speed phase
.4 during acceleration phase
.5 during the START at the correct value of 0 Hz
.6 during the start-up
.7 during DC limiting
.8 during overload limiting
.9 during positioning
Possible error codes
Error code
Meaning
E01.
Overcurrent, converter output current reaches 200% of the rated current during
continuous motion
E02.
Overcurrent, converter output current reaches 200% of the rated current during
braking
E03.
Overcurrent, converter output current reaches 200% of the rated current during
acceleration
E04.
Overcurrent, converter output current reaches 200% of the rated current under
other conditions Meanings
E05.
Thermal overload of the motor, detected by electronic motor protection
E07.
Overvoltage in the intermediate circuit, results in braking energy being too high
E08.
Błąd pamięci EEPROM
E09.
Overvoltage in the intermediate circuit, possible reason is too low voltage in the
power supply network.
E10.
Current measurement error, defective current measurement
E11.
CPU Error
E13.
Network power supply was switched while the START signal was active
E14.
Earthing current failure
E15.
Overvoltage at input
E21.
Excessive converter temperature
E22.
CPU - communication error
E25.
Error in the control board
E30.
Error in the IGBT drivers
E37.
EMERGENCY switch
E38.
Overload in frequency range < 2.0 Hz
E41.
Error in communication mode
E43. -45.
Internal data error
E50. -69.
Internal data error
E80.
Encoder error
E81.
Excessive rotation speed
10/2015
Page 20 of 24
Advertisement
Table of Contents
