Table of Contents
Advertisement
4 Assembly and installation
1. Elements of the door drive should be installed on the cabin door according to local conditions
or requirements. The motor must be installed at the provided location, together with
substructure provided for the toothed belt tensing. Two threaded openings have been
provided on transverse support 2 for control system housing, it can be alse installed within a
1.4 m radius around the motor, on the cabin roof. The electrical installation must generally
follow the switch plan diagram.
2. Connect the motor cable to the motor.
Before starting work on the door drive, all supplying cables must be disconnected
The motor must operate in a delta connection mode (factory setup).
Connect the motor cable as follows:
Motor connection
U
1
With the determination of door width, the controller recognizes the connecting of the cables
and rotates it in the inverter if necessary.
3. Open the housing cover of the door drive door drive LDO AC 3.0.
4. The incremental moment transducer is already factory installed on the drive motor after
shipment and must still be connected to the CN3 connector (see Figure 4-1) (see table at 2.).
Figure 4-1 Pulse generator connection
5. Power supply connection using the factory supplied power supply cable.
Design-wise, the power supply cable must be protected using a cable circuit
breaker
A
.
10/2015
and secured against switching the power supply on again.
V
W
2
3
3 A / C
or a power circuit breaker (motor circuit breaker) 1.6 to 2.4
Pulse generator connection
4 - 0 V DC and shield [ black ]
3 - 24V DC
2 - Channel B
1 - Channel A
[ red ]
[orange]
[green]
Page 11 of 24
Advertisement
Table of Contents
