Brother KIT CW Installation Manual page 25

b
To begin the upgrade, click "Upgrade
now".
→ The Upgrade wizard starts up, and the first dialog
box shown below appears.
c
Click "Next".
d
Type in the 15-digit product ID on the label
attached to the CD-ROM case, and then
click "Next".
→ The entered product ID and the serial number
automatically retrieved from the USB card writer
module is displayed.
Note
• Type in the CD key on the label attached to
the CD-ROM case for PE-DESIGN. The
product ID on the label attached to the CD-
ROM envelope for machines cannot be
used.
• If the product ID is incorrectly entered, the
message "The product ID is incorrect.
Check that a mistake was not made
during typing." appears.
• The uppercase letters "I" and "O" are not
used in the product ID.
• Each product ID is valid for only one USB
card writer module. A product ID that has
already been used cannot be used with a
different USB card writer module.
CASE 1: When PE-DESIGN NEXT is not installed on the computer
e
Click "Next" to access our server through
the Internet and retrieve the upgrade key.
→ If the upgrade key has been successfully retrieved,
the dialog box shown below appears.
f
Click "Next" to begin upgrading the USB
card writer module.
→ If the upgrade has been completed successfully, the
dialog box shown below appears.
g
Click "Finish".
Note
• If a warning appears at any time, follow the
instructions that are displayed.
21