[Step 2]Upgrading The Machine; [Step 2-1] Using Usb Media - Brother KIT CW Installation Manual

j
Carefully verify that the information has
been entered correctly and then click
"Certify".
Memo
• To change the entered information, click
"Back".
If an error message appears
Check below list for possible error(s). To close the
message, click "OK".
• Verify that the CD key and internal machine
identification number (No.) have been entered
correctly, and then repeat the procedure from
c
step .
• The CD Key is valid for use with only one
designated internal machine identification number
(No.). Check that the CD key has been entered
correctly, and then repeat the procedure from
c
step .
• Check the Internet connection, and then click
"Certify" again.
k
Write down the 8-digit Certification Key
that appears.
Note
• After upgrading the embroidery machine to
KIT CW, the Certification Key must be
entered in the embroidery machine Settings
screen.
INSTALLING THE UPGRADE KIT CW
l
Click "Finish".
[Step 2] Upgrading the Machine
The machine will be upgraded based on the
information obtained in [Step 1]. You can use USB
media or a computer to transfer the upgrade file to
your embroidery machine.
If USB media will be used, refer to the procedure
described in [Step 2-1]. If the machine will be
connected to the computer, refer to the procedure
described in [Step 2-2] (page 10).

■ [Step 2-1] Using USB media

a
While pressing the automatic needle-
threading button, turn the embroidery
machine on.
b
Copy the upgrade program downloaded in
step f of "Obtaining the Certification Key"
(page 8) to the USB media.
Note
• Copy only the upgrade program to a clean
re-formatted USB media; no other files
should be on this media.
9